NEED: Stepp-Motor-Controller with IEEE-488 IF

Thread View: de.sci.electronics

1 messages

[T] Back to Threads [V] Tree View [G] Group Articles

1 total messages Started by peny@ppc.lpc.eth Wed, 02 Mar 1994 16:01

#11

Author: peny@ppc.lpc.eth
Date: Wed, 02 Mar 1994 16:01

27 lines
945 bytes

We need a cheap Controller for small stepp motors with IEEE-488 (GPIB)
interface.

Requierments:
	one or two axis.
	programmable speed, direction, no of stepps.
	no acceleration requiered.
	Service request at end of mouvement.


The stuff from Klingler, Oriel and so on is good, but far to expensive
(here in Switzerland about US$ 3000.-).

We are also looking for some Micrometers with build in stepp-motor.

--------------------------------------------------------------------------------
					|	  __________
Peter Nyffeler				|	 / ___  ___ \  member of
ETH-Zuerich, Physical-Chemistry-Lab.	|	/     \/     \
Switzerland				|	|  ___  ___  | Soaring
e-mail:peny@ppc.lpc.ethz.ch		|	|     \/     | Club
fax: ..41 1 632 10 21			|	|  ___  ___  | Zuerich
tel: ..41 1 632 43 60			|	\     \/     /
					|	 \__________/
					|     + Control-line modell enthusiast
--------------------------------------------------------------------------------

Thread Navigation

This is a paginated view of messages in the thread with full content displayed inline.

Messages are displayed in chronological order, with the original post highlighted in green.

Use pagination controls to navigate through all messages in large threads.

Back to All Threads